Publicidad
Idiomas disponibles
Idiomas disponibles
Pairing The Remote ID
1.
Press "Stop" and "Seat Temp" for 3 seconds. Channels will show up on on
the LEDs. Set desired channel with "+" and "-". Press "Stop" to save settings.
•
Channel 1-5 - LEDs flashing
Channel 6-10 - LEDs on
2.
Press "Stop" and "Rear Wash" on the side control panel for 3 seconds.
The LED will start flashing. Press "Stop" on the remote to finish the
channel setting.
3.
To reset all remote settings, press "Stop" and "Front Wash" for 3 seconds.
Replacing Remote Batteries
•
If the remote is low, the first LED on the "Adjustable Water Pressure" and
"Dry Temp. " will flash. Please replace the batteries.
•
The LED will automatically turn off after 5 seconds to preserve energy.
Settings are changed to default when replacing the batteries.
16
Draining the Warm Water Tank
If you do not intend to use this product for an extended period of time,
drain the water from this product's warm water tank.
*Close shut-off valve
Before draining, unplug the power cord and wait 30 minutes until the unit has
cooled down. Do not insert your finger into the drain hole.
1.
Disconnect the power plug.
2.
Close the water shut-off valve.
3.
Press the release button on the right side of the bidet and pull it forward.
4.
Open the drain cap located on the back and bottom of the product and drain
out all the water in the tank. Beware of losing the drain bolt.
Avoid placing the product in a fully upright position.
Release
Button
17
Publicidad
