Vito Agro VIMETD7A Manual De Instrucciones página 46

Use only VITO-approved accessories for this petrol tiller or
technically identical parts. Failure to do so may result in
personal injuries or damages to the petrol tiller. If
necessary, they should be replaced by an official dealer.
For safety reasons, the fuel system components (hose, tap,
tank, tank cap and couplings) should be inspected
regularly regarding damage and leaks. If necessary, they
should be replaced by an official dealer.
Always keep warning and information stickers clean and
legible.
Keep all nuts, pins and bolts well tightened in order to
ensure a safe operation.
If any components or safety devices are removed for
maintenance works,
immediately.
When replacing the tines, pay attention to the type of tines
and if they match. Only use VITO-authorized tines.
Allow the combustion engine to cool down before putting
the equipment in a closed compartment.
Never store the tiller with petrol in the tank inside a
building. Petrol vapours may come into contact with flames
or sparks and ignite.
Store the petrol tiller in a dry area, with the fuel tank empty
in a well-ventilated location.
If you want to empty the tank, for example before the winter
period, the fuel tank should only be emptied outdoors.
Clean the machine thoroughly before storage, especially on
winter. Store the tiller in a good operating condition.
Store the machine with the spark plug cap removed.
Ensure that the petrol tiller is protected against misuse
(e.g., by children).
they must be repositioned
The petrol tiller should only be serviced by the brand's
technical assistance center, or other qualified personnel,
replacing any necessary parts with original parts.
Observe the safety instructions. Remove the spark
plug cap and wear tight-fitting gloves when working
with the tines.
Carry out all assembly work on a horizontal, firm and clean
surface. Respect the assembly positions and always ensure
a stable and safe position of the appliance.
Wear tight gloves when touching the tines.
Drive wheels
1. Mount the shaft on both wheels;
2. Fit the wheels shaft onto the drive shaft;
3. Insert the clevis pin into the middle hole of the wheel
shaft and drive shaft and then insert the R-clip.
Pay attention to the direction of rotation of the wheels.
Clevis pin
R-clip