Vito Agro VIMETD7A Manual De Instrucciones página 47

Front wheel
1. Remove the locking pins from the fixed wheel bracket
(2);
2. Adjust the wheel bracket to the front fixed bracket;
3. Insert the larger diameter pin into the center hole in the
fixed bracket and into the top hole in the wheel bracket.
At the same time place the outer washers and insert the
clevis pin on the inside of the brackets. Insert the R-clip;
4. Insert the smaller diameter pin into the lower hole in the
wheel bracket and into one of the lower adjustment
grooves. At the same time insert the clevis pin. You must
find the best position to make the operation easier.
Insert the R-clip.
Adjustment pin
When using the tiller:
1. Remove the pin from the adjustment groove and pull the
wheel upwards;
2. Insert the smaller diameter pin into the bottom hole of
the wheel bracket and into the upper groove. Place the
R-clip.
Adjustment pin
1. Loosen the quick-release lever and remove the
handlebar fixing bolt;
2. Align the handlebar holes (7) with the hole in the
handlebar stem;
3. Insert the handlebar fixing bolt into the holes with the
washers;
4. Adjust the handlebar height using the slotted teeth on
the stem and handlebar;
5. Tighten the handlebar quick-release device;
6. Place the cable ties;
7. Fit the guard and tighten with two bolts.
Locking pin
Locking pin
1. Fit the transmission shift rod (20) in the gear shift lever.
Insert the R-clip;
2. Fit the transmission shift rod to the lever on the gearbox.
Insert the R-clip.
1.
1. Place the rear mudguard on the fixed support. Tighten
the fixing bolts with the locknuts and washers;
2. Place the mudguard side supports with the flap towards
the rear and tighten the fixing bolts;
3. Adjust the mudguards according to the holes in the
supports. Fit the bolts, rubber sheets, washers and
locknuts.
Side
Rear
support
support
2.
Fixing bolts