Publicidad
Idiomas disponibles
Idiomas disponibles
The ambient temperature must not exceed the range of 1-40°C and the relative
humidity should not exceed 85%. Keep the unit away from any hot surfaces, direct
sunlight, drafts, air conditioners, radio receivers, digital telephony and magnetic
fields. The item placed on the beams should be evenly distributed over them.
Always use the appliance on an even, stable, clean, fireproof and dry surface and
out of the reach of children and persons with reduced mental, sensory and
intellectual functions. Place the unit in such a way that the main plug can be reached
at any time. Ensure that the power supply to the unit corresponds to that specified
on the identification plate!
ASSEMBLY OF THE DEVICE
IMPORTANT: if the product in the package was stored or transported in cold
conditions, keep it in the package for at least a few hours in the target room or
another room with a positive, stable temperature before unpacking and starting it.
1) [if necessary] Fix the control head (1) on the target vertical plane, e.g. a wall
etc. Use the holes in the mounting bracket (G) for installation. The knobs on
both sides of the head are used to loosen and stabilize the head in a given
position.
2) Screw in the feet (2 for each beam) and level each beam using these feet.
3) Connect the power cables of both beams (C) to the cables from the control head
(B).
4) Depending on the choice of power source, place the batteries under the
unscrewed cover on the back of the head (a - in the picture below) or connect
the plug from the power supply to the socket (b):
5) [optional] Connect an external device such as a printer to the RS232 male
socket (D-Sub / DB9) located on the back of the head (c) according to the
diagram:
Publicidad
