Publicidad
Idiomas disponibles
Idiomas disponibles
Throttle/Choke Control
Hour Meter/
Indicator Panel
Seat Adjustment Lever
Fuel Tank Cap
Now that you have set up your riding mower, it's important to become acquainted
with its controls and features. Refer to Figure 11.
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the
riding mower when facing forward while seated in the operator's seat.
Deck Height Index
The deck height index consists of six index notches located on the front/
right of the seat box frame. Each notch corresponds to a 1⁄2" change in
the deck height position ranging from 1-1⁄2" at the lowest notch to 4
inches at the highest notch.
Deck Lift Handle
The deck lift handle is located on the front/right of the seat box frame,
and is used to raise and lower the mower deck.
Pull the handle to the left out of the index notch and push downward to
lower the deck, or pull upward to raise the deck. When the desired height
is attained, move the lift handle to the right until fully in the index notch.
Cup Holder
The cup holder is located toward the rear of the RH console to the right
of the operator's seat.
Storage Tray
The storage tray is located at the rear of the RH console.
OPERATION
Parking Brake
Control Lever
Deck Lift
Deck Height
Handle
Index
LH Drive
RH Drive
Control Lever
Figure 11
RH and LH Drive Control Levers
The RH and LH control levers are located on each side of the operator's seat. These
hinged levers pivot outward to open space to permit the operator to either sit in
the riding mower seat, or to dismount the riding mower. The levers must be fully
opened out and in the neutral position to start the riding mower engine.
Each lever controls the respective RH or LH transmission. Consequently, these levers
control all of the movements of the riding mower. Driving and steering utilizing
these control levers is quite different from conventional riding mowers, and will
take some practice to master. Refer to the Driving the Riding mower section for
instructions on using the control levers.
Seat Adjustment Lever
The seat adjustment lever is located below the front/left of the seat. The lever
allows for adjustment of the fore to aft position of the operator's seat. Refer to
Service and Maintenance for instructions on adjusting the seat position.
Power Take-Off (PTO) Switch
The PTO switch is located on the RH console to the right of the operator's seat. The
PTO switch operates the electric PTO clutch mounted on the bottom of the engine
crankshaft. Pull the switch knob upward to engage the PTO clutch, or push the knob
downward to disengage the clutch. The PTO switch must be in the "disengaged"
position when starting the engine.
13
PTO Switch
Ignition Switch
Cup Holder
Storage Tray
Publicidad
