ALPA MEGArod Manual De Instrucciones página 8

ALPA_DIGITAL_INDICATOR_MEGArod IP54
SWITCHING OFF
The dial gauge goes automatically into stand-by if not used for 20 minutes. The value of the origin
is retained by the sensor (Inductive system), and the instrument automatically restarts with any
movement of the measurement probe, RS command.
The instrument can be switched off completely for a long period of non-use, but this will necessitate
a zero reset on restart (the origin will be lost): prolonged press (>4 sec) on button.
RE-INITIALISING THE INSTRUMENT
All settings (unit and measuring direction) will remain after a battery change. The initial instrument
settings can be restored at any time by a prolonged press (>4 sec) on button until the message
CLEAR is displayed.