Rational iVario XS Instrucciones De Modificación página 7

1 | MI_2205: Master conversion kit
Sharp edges on the housing
Risk of cuts on the housing when working in the electrical compartment.
Wear protective gloves.
Pre-requisite
The unit is disconnected from the power.
n
If 2 cables 40.07.476 were already connected in series on the replaced
n
master (see step 2), then you only have to install the new master (step 1)
and do not need to install the 2 cables (step 2). This is because, in this case,
the IO PCB has already been replaced and the installation of the additional
cables would lead to a reverse polarity of the motors.
Work steps: Wiring the adapter cabling
1. Replace the master.
2. Connect the 2 cables from kit 40.07.476 in series with the power supply
cable for the pan and lid tilt motors. Connect the cable with the grey guard
to the left motor (1). Connect the cable with the red guard to the right mo-
tor (2).
>>
The adapter cabling has been wired.
10 / 56
CAUTION
1
2