HOMCOM A90-146V01 Instrucciones De Montaje página 22

.2 pedal installation
1）Take out the pedal, you will find that there are "L" and "R" on the pedal. First, drop two
drops of red thread locking fluid on the thread of "R" pedal, and then turn it into the right
crank threaded hole, turn it clockwise until it can't be turned, and then lock it with our special
open-ended wrench. Take out the "L" pedal, and drop two drops of thread locking fluid on the
thread, and then turn a part of it anticlockwise to the left crank threaded hole until it can not
be turned, and then lock it with a special open-ended wrench.
(Note: the crank is also marked with "L" and "R", which is corresponding to the mark on the
pedal. If it is installed in reverse, the product may be damaged by the crank sliding thread.
And the pedal must be locked, otherwise the pedal may fall off after a long time.)