Seko WAREDOSE 35 Manual De Instalación página 7

EN
WAREDOSE 35
Delivery Line:
Attach a PVC tube to the delivery side of the detergent pump. Attach the other end to the injection connector.
Make a 10 mm hole in the vertical side of the tank, just above the water level, and fix the connector as shown in
the Picture 3.

Always use the foot filter and make sure that it reaches the bottom of the tank. Periodically clean it
from possible residues.
2.2.2 Rinse Plumbing (peristaltic model)
The following installation steps apply for the rinse pump:
Suction Line:
•
Assemble the foot filter to insert into the rinse tank. Insert the outlet poly tube into the flat side of the weight and
out the other side. Push the filter into the end of the tube. Lock the tube by pushing the weight to the filter
holder and rotating it at the same time, till they are completely flush (Picture 4).
•
Cut a suitable length of inlet tubing and connect between the suction (left) side of the pump and the rinse tank.
Picture 4
Delivery Line:
• Install the outlet tubing into the side or bottom of the warewasher rinse line between the rinse solenoid valves and
the rinse jets. (Picture 5)
• Cut a suitable length of outlet tubing and connect between the discharge (right) side of the rinse pump and the
injection fitting;
• Hand-tighten the compression nuts on both the injection fitting and pump.
0000138112
Picture 3
DESCRIPTION
1 TANK WALL
2 INJECTOR
3 4X6 CRYSTAL PVC TUBE
4 GASKET
5 WASHER
6 NUT
7 WATER LEVEL
weight
6 mm OD PVC tube
Filter
rev. 1.0 5