cecotec BOLERO COOLMARKET COMBI 250 WHITE E Manual De Instrucciones página 35

ENGLISH
the door stop (17). On the upper door's left side, insert the left door stop (18) and the left
dowel (19) (included in the plastic bag) and secure it with the screw (15). Keep the right
door stop and dowel. Fig. 13
Use the Allen key (included in the plastic bag) and a Phillips screwdriver to loosen the
9.
screws and remove the upper-right hinge from the lower door. Then carefully lift the door
up and remove it. Then carefully lift the door up and remove it. Fig. 14
10. Place the lower door on a soft surface with the inside facing up. On the lower door's right
side, unscrew the screw (22) and remove the dowel (21) from the door stop (20). On the
lower door's left side, insert the left door stop (23) and the left dowel (19) (included in the
plastic bag) and secure it with the screw (15). Keep the right door stop and dowel Fig. 15
11. Replace the screw gap covers and screw the centre plate to the right. Fig. 16
12. Tilt the refrigerator carefully to gain access to its base. Remove the two adjustable lower
legs (27), then remove the lower hinge (25) by unscrewing the screws (26). Fig. 17
13. Loosen the lower hinge pin and remove it. Rotate the hinge and reinsert the lower hinge
pin (28), then tighten it. Fig. 18
14. Place the lower hinge on the left side of the refrigerator base and secure it with the
screws (26). Replace the adjustable lower legs and partially secure them. Fig. 19
15. Place the refrigerator in an upright position and carefully insert the lower door into
the upper hinge of the lower door. At this point, the door will not be attached to the
refrigerator. Hold it firmly so that it does not fall off. Install the left hinge (in the plastic
bag) making sure that the lower door is secured in place. Fig. 20
16. Position the upper door on the left side and place the middle hinge shaft in the upper
door's bottom hole. Install the upper-left hinge (29) (included in the plastic bag) and
screw it with the screws removed in step 9 (6). At this point, the door will not be attached
to the refrigerator, but hold it firmly so that it does not fall off. Fig. 21
17. Remove connectors 31 and 32 from the top left side of the refrigerator. Connect 30 to 31.
Then plug connector 32 to the door switch located on the upper-left hinge cover. Fig. 22
18. Install the upper left hinge cover (5) using the screw (33) as shown in figure 23, on the top
of the refrigerator. Fig. 23
19. Open the upper door, reinstall the shelves, and close the door.
Please note
- If the refrigerator has a handle, you must reverse its position by following these
instructions:
- Remove the covers from the handle screws and then loosen the screws. Pull the handle to
remove it and replace it on the right side. Screw the screws back in and place the covers.
Fig. 24
Fig. 24
Handle covers
1.
2. Special screws
B O LE R O COOLM ARKET COM BI 2 50 W HITE E
68
B O LE R O COOLM ARKET COM BI 2 50 INOX E
3. Door handle
4. Screw gap
4. OPERATION
The display panel is located on the top inside of the refrigerator.
When the cooling system is switched on for the first time, all icons on the display light up for
2 seconds.
The temperature can be adjusted by pressing the '
the indicator of the current mode will switch off while the indicator of the next mode will light
up, and the mode setting will be confirmed if no key is pressed within 5 seconds (otherwise
the mode setting will be invalid). After the setting has been made, the temperature will be
immediately controlled according to the mode setting.
Fig. 3
1. Fast Cool icon
2. Temperature level icons
3. Temperature level selection
The temperature mode cycle is as follows: "5→4→3→2→1→FAST COOL→5"
5 When you need a cooler temperature.
4
3 Normal use.
2 When you don't need a cooler temperature.
1
Adjusting the freezer compartment temperature
The freezer temperature can be adjusted with the knob in the following way:
- When the temperature mode remains unchanged, turn the temperature knob clockwise–
the temperature of the refrigerator compartment will decrease while the temperature of
the freezer compartment will increase.
- When the temperature mode remains unchanged, turn the temperature knob
counterclockwise–the temperature of the refrigerator compartment will increase while
the temperature of the freezer compartment will decrease.
- It's recommended to set the temperature knob to the middle position. When a lower freezer
temperature is required, turn the temperature control knob properly counterclockwise to
decrease the freezer compartment temperature (note that the refrigerator compartment
temperature will increase simultaneously). When the desired temperature is reached, be
sure to properly turn the knob back to the middle position.
BOLERO COOLMARKET COMBI 250 W HITE E
BOLERO CO OLMARKET CO MBI 250 IN OX E
ENGLISH
' key. Every time " " is pressed,
69