Descargar Imprimir esta página

EmberGlow VFF26NLMA Manual De Instrucciones página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT: Vent-free heaters add moisture
to the air. Although this is beneficial, installing
heater in rooms without enough ventilation air
may cause mildew to form too much mois-
ture. See Air for Combustion and Ventilation,
pages 7.
CHECK GAS TYPE
Be sure your gas supply is right for your heat-
er. Otherwise, call dealer where you bought
the heater for proper type heater.
CLEARANCES TO
COMBUSTIBLES
WARNING: You must main-
tain the minimum clearances.
If you can, provide greater
clearances from floor, ceiling,
and joining wall. Measure from
outermost point of heater.
This appliance is factory
preset for propane/LP gas.
No changes are required for
connecting to propane/LP.
Only a qualified installer or service
technician can perform gas selec-
tion and connecting to gas supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited.
CAUTION: To avoid gas leak-
age for the gas not being used at
the inlet of regulator, a qualified
installer or service technician
must use supplied cap.
200252-01A
INSTALLATION
A. Clearances from outermost point of heater
to any combustible side wall should not be
less than 12".
B. Clearances from the heater to the ceiling
should not be less than 48".
Note: When heater is installed directly on car-
peting, tile or other combustible material, other
than wood flooring, the heater must be installed
on a metal or wood panel extending the full
width and depth of the heater. Installation in
the provided mantel fulfills this requirement.
Side
Wall
Figure 4 - Minimum Clearances to Wall
GAS SELECTION
You will notice a color coded
plunger on the inside of the regu-
lator. This is normal. When the in-
let connection fitting is inserted
and tightened, this plunger will
be pushed back by the fitting
making all of the adjustments
for the gas being supplied. DO
NOT REMOVE THE PLUNGER.
The regulator will not work.
The inlet regulator is color coded
for identification of the correct
gas type. Blue is for propane (LP
gas) and yellow is for natural gas.
www.sureheat.com
Minimum Wall and Ceiling
Clearances
Ceiling
48"
12"
Min.
Min.
and Ceiling
12"
Min.
Side
Wall
9

Publicidad

loading