Descargar Imprimir esta página

QEP 22900Q Manual De Operación página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

2 . Create "drip loop" in the cord (see FIGURE 13)
FIGurE 13
maKinG CUtS
The edge of the cutting table has easy-to-see
dimensions (in both inches and centimeters)
for cutting accuracy .
IMPORTANT: ALWAYS LET THE BLADE CUT AT
ITS OWN SPEED. DO NOT FORCE THE MATERIAL
BEING CUT. ALWAYS CHECk THE BLADE FOR
CRACkS OR DAMAGE BEFORE EACH USE.
maKinG 90° riP CUtS
1 . Install the rip guide by placing it at the
desired position according to the width of
the cut you are making .
2 . Place the material to be cut against the
rip guide .
3 . Carefully and slowly feed the material into
the blade (see FIGURE 14) .
4 . If necessary, the rip guide can be removed
when cutting large format tile .
FIGurE 14
maKinG 22.5° & 45° anGLe CUtS
1 . Place the angle guide on the top of the
rip guide .
2 . loosen knob . Position guide to desired
angle (22 .5° & 45°) and place tile in guide .
3 . Carefully push the angle guide and material
towards the blade (see FIGURE 15) .
FIGurE 15
maKinG 15°, 30° & 45° miter CUtS
(see FIGURE 16)
1 . The right cutting table can be angled at 15° or
30° or 45° .
2 . Two braces under the table unfold to support
the table at the desired angle .
3 . Place the material to be cut onto the right
cutting table .
4 . Carefully and slowly feed material into the
blade .
FIGurE 16
FOLdinG BenCH StOP
(see FIGURE 17)
1 . Convenient Bench Stop keeps saw in place
while making cuts .
FIGurE 17
– 8 –

Publicidad

loading