Publicidad
Idiomas disponibles
Idiomas disponibles
Ampere rating
More than
No more than
0
6
6
10
10
12
12
16
TAbLE 1
TO REDUCE THE RISk
OF ELECTROCUTION, kEEP ALL CONNECTIONS
DRY AND OFF THE GROUND. DO NOT TOUCH
PLUG WITH WET HANDS.
2 . Ground Fault Circuit Interrupter (GFCI)
protection should be provided on the circuit(s)
or outlet(s) to be used for the tile saw .
Receptacles are available having built-in GFCI
protection and may be used for this measure
of safety .
3 . uSE propEr EXTEnSIon cord. Make
sure your extension cord is in good condition .
When using an extension cord, be sure to use
a cord heavy enough to carry the current your
product will draw . An undersized cord will
cause a drop in line voltage, resulting in loss
power and overheating . TABlE 1 shows the
correct size to use depending on cord length
and nameplate ampere rating . If in doubt, use
the next heavier gauge . The smaller the gauge
number, the heavier the cord .
noTE: When using an extension cord, ensure
all cords are no smaller than #12 gauge, rated
at a 20-amp minimum, and equipped with
3-prong plugs . Use of anything smaller may
result in overheating or burn out of the motor . It
is recommended to have an electrician check
the voltage at the saw motor to ensure proper
voltage to run the saw efficiently and safely.
CALIFORNIA
PROPOSITION 65
SOME DUST CREATED
BY POWER SANDING, SAWING, GRINDING,
DRILLING AND OTHER CONSTRUCTION
ACTIVITIES CONTAIN CHEMICALS kNOWN
TO THE STATE OF CALIFORNIA TO CAUSE
CANCER, BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.
Volts
120 V
25 ft .
240 V
50 ft .
18
18
16
14
Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other
masonry products
• Arsenic and chromium from chemically-treated
lumber
Your risk from these exposures varies, depending
on how often you do this type of work . To reduce
your exposure to these chemicals: work in well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specifically designed to filter out microscopic
particles .
DESCRIPTION
Before attempting to use any tool, be sure to
familiarize yourself with all the operating features
and safety instructions .
KnOW yOUr SaW
Your tile saw has many built-in features for fast,
efficient cutting of ceramic, porcelain, marble,
slate or limestone wall or floor tile. The durable 7
inch blade cuts tile up to 1-1/8 in . (29 mm) thick .
The adjustable rip and angle guides allow 90° rip
cuts and 22 .5°or 45° angle cuts on both the right
and left sides . The right cutting table is hinged so
it can be adjusted for 15°, 30° and 45° miter cuts .
The right table has a built-in water reservoir for
cooling the blade .
– 4 –
Total length of cord in feet
50 ft .
100 ft .
100 ft .
200 ft .
AWG
16
16
16
14
16
14
12
Not recommended
150 ft .
300 ft .
14
12
12
Publicidad
