Publicidad
Idiomas disponibles
Idiomas disponibles
FIGurE 8
FIGurE 9
inStaLLinG tHe anGLe GUide
1. The angle guide is designed to fit on top of the
rip guide . Simply place angle guide onto the
top of the rip guide . (see FIGURE 10)
NOTE: The angle and rip guides can be placed on
either the left or right side .
FIGurE 10
OPERATION
IMPORTANT: AlWAYS turn off the saw and
remove the plug from the outlet BEFORE adding
or removing accessories and making adjust-
ments .
THE SAW COULD RESULT IN ACCIDENTAL
STARTING CAUSING POSSIBLE SERIOUS
PERSONAL INJURY.
BeFOre StartinG tHe SaW
1 . Make sure saw is unplugged .
2 . Remove the right cutting table, secure the
waterplug and fill the water reservoir to the
fill line (see FIGURE 11). Do not fill above this
level .
NOTE: AlWAYS keep enough water in the
reservoir when operating the saw . DO NOT let
the saw run dry .
3 . Re-attach and close right cutting table .
IMPORTANT: ALWAYS completely drain the
water reservoir and clean thoroughly after
each use.
FIGurE 11
tO Start tHe SaW
1 . Remove cord from side compartment and
connect it to a GFCI (Ground Fault Circuit
Interrupter) protected outlet
(See FIGURE 12)
3 .Push On/Off switch to the "On" position .
FIGurE 12
– 7 –
FAILURE TO UNPLUG
Publicidad
