Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
TO AVOID ACCIDENTS,
ALWAYS DISCONNECT THE TOOL FROM
THE POWER SOURCE BEFORE CLEANING OR
PERFORMING ANY MAINTENANCE
Please do not try to service this machine on
your own .
Avoid using solvents when cleaning plastic
parts . Most plastics are susceptible to damage
from various types of commercial solvents
and may be damaged by their use . Use clean
cloths to remove dirt, carbon dust, etc .
DO NOT AT ANY TIME
LET BRAkE FLUIDS, GASOLINE, PETROLEUM-
BASED PRODUCTS, PENETRATING OILS, ETC.
COME IN CONTACT WITH PLASTIC PARTS.
THEY CONTAIN CHEMICALS THAT CAN
DAMAGE, WEAkEN OR DESTROY PLASTIC.
1 . ALWAyS clean the tile saw after each use
and store it in a dry location .
2 . ALWAyS wipe off all exterior surfaces and
keep the cutting table clean and free of
all debris .
3 . ALWAyS check the blade for cracks or
damage BEFORE each use .
4 . ALWAyS store the cord in the compartment
underneath the saw after each use .
diamOnd BLadeS
• Use only 7 in. (180 mm) continuous rim
diamond blades with a 5/8" arbor opening in
this saw . Failure to do so may result in severe
bodily injury and damage to the saw .
diamOnd BLade dO'S & dOn'tS
1 . DO inspect blades daily for cracks or uneven
wear . Discard cracked, chipped or bent
blades!
2 . DO use manufacturer's recommendation
for matching the right blade with the right
material being cut .
3 . DO inspect the arbor shaft for uneven wear
before mounting the blade .
4 . DO use blades with the correct arbor size on
a compatible arbor shaft .
5 . DO ensure the blade is mounted with the
rotation arrow in the proper direction and is
securely tightened with a wrench .
6 . DO wear proper safety equipment at all
times when operating the saw . Wear
goggles and dust mask at all times when
operating saw .
7 . DO periodically check the blade for cracks
or bond fatigue .
8 . DO ensure that blade is traveling through
water reservoir for wet cutting .
9 . DO NOT operate the saw without all safety
guards in position .
10 . DO NOT operate the saw with blades larger
or smaller than recommended .
11 . DO NOT use blades not recommended for
wet cuts .
12 . DO NOT exceed maximum RPMs
recommended by the blade manufacturer .
13 . DO NOT force the material into the blade .
let the blade cut at its own speed .
14 . DO NOT cut material not recommended by
the blade manufacturer .
TROUBLESHOOTING
OVerHeatinG OF SaW:
1 . Turn saw off and let it rest until motor is cool
to the touch .
2 . Check and clean the ventilation slots,
removing blockage and dirt .
tHe SaW dOeS nOt Start:
1 . Check that power cord is properly
plugged in .
2 . Check outlet power source and circuit
breaker .
3 . Check that Ul -listed extension cord is in
working order if used .
Q.e.P. CUStOmer SerViCe:
1-866-435-8665
– 9 –
Publicidad
