Bosch GAL18V-40 Instrucciones De Funcionamiento Y Seguridad página 7

FIG. 2
Read instructions of the
drill driver and the
mounting hardware prior to drilling hole.
Note: The consumer is responsible for damage
or injury caused by incorrect installation.
Use mounting hardware which is appropriate
for the wall type and suitable for the weight
of charger and heaviest battery pack.
If the charger is installed without the correct
hardware, the product may be unstable and
cause property damage or personal injury.
Do not wall mount the charger where the
weight of the charger and battery cannot be
supported. If the strength of the wall mount
location is not strong enough, the charger
can fall off and cause an injury. Note: It is the
consumer's responsibility to ensure that the wall
can properly support the total weight.
Check to be sure that there are no hidden
live wires, water pipe, or gas pipe behind the
mounting area. Cutting or drilling into any of
these may cause serious injury or death.
Do not mount to any
surface other than a
vertical wall. Mounting of the charger is
designed for vertical surfaces only. Improper
installation may cause property damage or
personal injury.
The charger can be mounted to a wall using wall
mounting slots 5 (Fig. 2).
a. Locate mounting area on the wall.
Wall Mounting
5
5
b. Mark two points on a vertical line 2.84"
(72mm) apart.
c. Select the appropriate screws and anchors
(if necessary) for the material of the wall.
(Mounting hardware not included.)
d. Drill into wall with appropriate drill bit.
If anchors are to be used, follow anchor
hardware manufacturer's instructions.
e. Screw in two round-head screws (not
included) with a diameter of 0.2" (5mm)
to maximum 0.25" (6.5mm) into wall or
anchors. Leave approximately 0.13" (3.3
mm) space between bottom of screw head
and wall.
f. Position the charger screw slots over the
mounting screws. Push charger towards the
wall and slide it down to secure charger to
mounting screws.
Note: Make sure the charger is securely
mounted and that it is tight against the mounting
surface. Adjust screw exposure as necessary to
ensure the charger is flat against the wall.
7
2.84"
(72mm)