KNF Labor N022.18 Manual De Instrucciones página 85

Diaphragm pump N022.18, N026.18
Cooling air sup-
ply
Installation loca-
tion
Translation of Original Operating Instruction, KNF 121224-121388 04/23
6 Setup and connection
à
Only connect the pump in accordance with the operating
parameters and conditions described in Chapter 3 Techni-
cal data [} 13].
à
Observe the safety instructions (see Chapter Safety).
à
Before connecting, store the pump at the installation loca-
tion to allow it to reach the room temperature (no conden-
sate may form).
WARNING
à
Make sure that the installation location is dry and that the
pump is protected against rain, splash, gushing, and drip
water as well as from other contamination.
à
Select a secure location (flat surface) for the pump.
à
Protect the pump from dust.
à
Protect the pump from vibration, impact and external dam-
age.
à
Make sure that it is easy to operate the power switch.
Danger of burning on hot surfaces
Hot surfaces could occur if the pump
overheats.
à
When installing the pump, make
sure that sufficient cooling air in-
feed and discharge is ensured.
Setup and connection
25
DE
EN
FR
ES
IT