Graef CM1012 Manual De Instrucciones página 22

Make sure that the unit cannot topple over.
●
Choose the location in such a way that children cannot reach the connecting cable of the
●
unit.
Do not place the unit on hot surfaces, such as hotplates, or near them.
●
Never use the unit outdoor and store in a dry location.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The socket has to be easily accessible so that the connecting cable can be removed easily
●
in case of emergency.
ELECTRICAL CONNECTION
For safe and fault-free operation of the unit, the following requirements have to be met during
the electrical connection:
Before connecting the unit, compare the connecting data (voltage and frequency) on the
●
type plate with those of your energy network. These details must correspond so that no dam-
age occurs to the unit. In case of uncertainty, contact a qualified electrician.
The socket has to be protected at least by a 10 amps circuit breaker.
●
Make sure that the connecting cable is not damaged and not laid across hot surfaces or
●
sharp edges.
The connecting cable must not be stretched tightly.
●
The electric safety of the unit is ensured only when it is connected to a socket with protec-
●
tive conductor installed correctly. Operation on a socket without protective conductor is
forbidden. If in doubt, let the house installation be checked by a skilled electrician. The man-
ufacturer does not assume responsibility for damage which has been caused by missing or
interrupted protective conductor.
PRIOR TO FIRST USE
Clean all parts as described under "Cleaning".
ATTACHING THE BEAN CONTAINER
Fit the coffee bean container on the unit.
●
If necessary, use a flat-blade screwdriver to tighten the lock screw of the container.
●
Open the outlet of the coffee bean container by pulling out the sliding lock.
●
Remove the cap of the bean container and fill it with coffee beans.
●
Fit the cap.
●
GROUP HANDLE HOLDER
Place the group handle holder. The group handle holder is height adjustable. To find the right
position for the group handle, loosen the screw and adjust the height. Do not loosen completely
the screws. The group handle holder can be moved up or down depending on the size of the
group handle. When you have found the right size, tighten the screw. The group handle holder
22