MTX Audio TH4000D Manual De Usuario página 4

www.mtx.com - www.mtx.eu.com
Speaker Terminals - Connect subwoofer(s) to these terminals. If using two subwoofers or a dual voice coil sub-
woofer, respect the phase.
Attention : The two (+) connectors are wired parallel internally. Same for the two (-) connectors.
Thermal Protection - This LED illuminates red when the amp reaches 100°C. The LED also turns red when the
power supply goes below 9V or over 19,2V.
Short Circuit Protection - This LED will flash yellow when the speaker outputs will short circuit. Without signal,
this LED can remain yellow when the speaker outputs are short circuited.
(+12) Power Terminal - This is the main power input for the amplifier and must be connected directly to the posi-
tive terminal of the vehicles battery for proper operation. Use caution when installing (+12) power cable in the
vehicle. Avoid running this cable parallel with RCA cables, antennas, or other sensitive equipment due to massive
currents that can induce noise into the audio system. It is also very important to have a tight, secure connection
2
for maximum performance. MTX recommends using 2x 50mm power wires with the MTX TH4000D amplifier.
Remote Terminal - The amplifier can be turned on by applying 12 volts to this terminal. Typically this voltage is
supplied by a wire from the source unit marked "remote" or "power antenna".
Ground Terminal - A proper ground is required for your amplifier to operate at peak performance. A short ground
cable the same diameter as the power cable should be used to attach the ground terminal directly to the chassis
of the vehicle. Always remove paint, dirt or debris to expose bare metal where the ground will be attached.
EBC Port (External Bass Control) - The Remote Subwoofer Level Control (EBC) plugs directly into this port, while
the EBC itself can be placed anywhere in the vehicle for on demand bass adjustments. EBC is included.
Master/Slave Switch - Used to put the amp in Master mode or Slave mode when bridging two TH4000D's. For
more details, see Master/Slave Mode section below.
Master/Slave Port - Used to connect two TH4000D when used in Master/Slave mode. The RJ15 cable is included.
For more detail see Master/Slave mode section below.
Master Slave Mode
For MAXIMUM output power, two TH4000D amps can be bridged together.
1. Decide which TH4000D is the "Master" amp. The other one will be the "Slave" amp. Set the "Bridge Mode"
switch (16) to "Master" on the master amp. Set the slave amp to "Slave" (16).
2. Connect the input signal from the source unit to the RCA inputs of the master amp. The slave amp doesn't
need RCA connection. It will take the signal from the master amp through the RJ15 cable.
3. Connect the included RJ15 cable to both amps.
4. Adjust the gain, x-over, subsonic filter and phase on the master amp. All slave amp controls are disconnected
through slave mode. The master amp fully manages the slave amp.
5. Your (+) speaker output is the (+) speaker output from the master amp.
6. Your (-) speaker output is the (+) speaker output from the slave amp.
Note: The EBC remote works fine in master/slave mode. It only needs to be connected it to the master amp.