Toyotomi TD-C1416 Manual De Instrucciones página 5

3. OPERATING INSTRUCTIONS
The buzzer will alarm for several times when the unit is powered
on, the LED will show the room humidity for 3 seconds, then it will
automatically turn off.
1. Turn on/off
Press to start the unit, when the unit is stop; or press
shutdown it, when the unit is operating.
2. Humidity setting
Press the key to enter humidity-setting state, then press
or to adjust the humidity from 40% to 80%, every setting is
5%, the LED flashing display when adjusting. Stop pressing for
5 seconds, it will return to normal display. The default value of
humidity is 55%.
3. Fan-speed setting
Press to set the fan speed to high or low, and the corre-
sponding fan speed light will be lighted.
4. Swing setting
After the machine is started, press
outlet leaf's swing.
5. Time-setting
Press to enter boot-time setting state when the unit is stop,
then the LED will display the time, you may press
to adjust the automatic boot time from 1 to 24 hours. Press
to enter shutdown-time setting state when the unit is running,
then the LED will display the time, you may press
to adjust the automatic shutdown time from 1 to 24 hours. Once
turned on or off by user or entering water-full state, the unit may
lost the timing function.
4. DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn
on, the operation will stop automatically and the buzzer will beep
15 times to alert the user, that the water need to be emptied from
the drainage tank.
5. EMPTYING THE DRAINAGE TANK
1. Lightly press on the sides of the tank with both hands and pull
the tank out gently.
2. Discard the collected water.
to
to start or stop the air-
or button
or button
4
NOTE
1. If the drainage tank is dirty, wash it with cold or lukewarm water.
Do not use detergent, scouring pads, chemically treated dust
cloths, gasoline, benzene, thinner, or other solvents, as these
can scratch and damage the tank and cause water leakage.
2. When replacing the drainage tank, press the tank firmly into
place with both hands. If the tank is not positioned properly, the
"TANK FULL" sensor will be activated, and the dehumidifier will
not operate.
6. CONTINUOUS WATER DRAINAGE
The unit features a continuous drainage port. Using a plastic pipe
(with an inner diameter of 10mm) inserts into drain hole (on inter-
mediate plate), reach out from side of water tank, install it in place,
and arrange the drain pipe.
The water in the drainage tank can be continuously drained out
from the continuous port on the unit.
ENGLISH