Publicidad
Idiomas disponibles
Idiomas disponibles
PRECAUTIONS!
• Not
recommended
children under 14 and always under
adult supervision.
• Its soft couch can support the whole
body and its soft armrests and foot
support
make
comfortable and safer.
Caution:
Consult
before
beginning
appliance. This advice is especially
important for those suffering from
health problems.
ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there.
The assistance of a second person is
recommended for assembling this unit.
Take the components out of the box
and make sure that you have all of the
pieces, Fig.1:
(1) Main support
(3) Couch support.
(4) Telescopic foot tube.
(5) Footrest.
(6) Footrest holding bar.
(7) Grips.
(10) Bottom foam cover.
(11) Rotation plates.
(13) Protective cover.
(14) Locking plate.
(16) Safety strap.
(26) Foam covers.
(34) Footrest retainer knob.
(35) Knob for telescopic tube.
(39) Screws M-8x60.
(41) Screws M-8x40.
(42) Screws M-6x45.
(45) Curved washers M-8.
(46) Curved washers M-6.
(47) Support bushes.
for
use
by
exercise
more
your
doctor
to
use
this
(48) Self-locking nuts M-8.
(49) Self-locking nuts M-6.
ASSEMBLY.-
1.- Position the main support (1) as
shown in Fig.3.
Next, make sure to lower the lock
plates (8 and 9) in the direction of the
arrow so that they are set horizontally,
as shown in Fig.3.
2.- Fit the protective covers (13) as
shown in Fig.3.
3.- Take the handgrip (7) and insert
screw (39) along with washer (45) into
the top hole and position it on the
main support as shown in Fig.4.
Fit washer (45) and nut (48) and
tighten securely.
Now fit the spacer (47), the locking
plate (14), bushing (47) and the self-
locking nut (48) onto the previously
fitted screw (45) and tighten lightly
until the locking plate (14) rotates.
Fit screw (41), along with washer (45)
into the bottom hole on the handgrip
(45) and tighten the self-locking nut
(48) securely, Fig.4.
Perform the same operation for the
handgrip on the other side.
FITTING THE FOOT SUPPORT.-
4.- Take the footrest (5) and insert it
inside the end of the telescopic tube
(4). Secure it by holding the knob (34)
as shown in Fig.5 and then locking the
foot support by turning the knob (34)
clockwise, Fig.5.
Place the bottom foam cover (10) onto
the telescopic tube (4) as shown in
Fig.5. Insert screw (42), along with
washer (46) and tighten securely
using nut (49). Next, place the foam
covers (26) on each end of the tube,
Fig.5.
15
Publicidad
