Publicidad
Idiomas disponibles
Idiomas disponibles
Noise reduction
To reduce the impact of noise emission, limit the time of operation, use low-noise
operating modes as well as wear personal protective equipment.
1. Only use the product as intended by its design and these instructions.
3. Use correct application tools for the product and ensure they in good condition.
5. Maintain this product in accordance with these instructions and keep it well lubricated
KEEP GUARD IN PLACE and in working order.
ALWAYS check the tool for damaged parts. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine whether it will
operate properly and perform its intended function. Check for misalignment or binding
of moving parts, broken parts and any other condition that may affect the tool's operation.
A guard or other part that is damaged should be properly repaired or replaced by a
qualified person.
The blade guard on your saw has been designed to automatically raise when the arm is
brought down and to lower over the blade when the arm is raised.
The guard can be raised by hand when installing or removing saw blades or for inspection
of the saw.
NEVER RAISE THE BLADE GUARD MANUALLY UNLESS THE SAW IS TURNED OFF.
ACCESSORIES
The Compound Mitre Saw is supplied with the following accessories as standard:
EN
150
Publicidad
