Adler europe AD 4495 Manual De Uso página 4

should be consulted in this regard.
15. NOTE: The milk frother has a heating function. Be very careful while opening the lid
and pouring milk in so as to avoid getting burnt.
16. To avoid being splashed with milk or foam (which may be hot), always put the lid on the
milk frother before you switch it on.
17. After each use wait for 2 minutes to allow the thermostat to cool down.
1. DEVICE DESCRIPTION
a. Lid
c. Whisk for heating the milk
e. Minimum filling level mark
g. Control button
2. Filling level indicators
a. MAX level for heating milk:300ml (2a)
b. MAX level for cold / hot milk frothing:130ml (2b)
INSTRUCTIONS FOR USE
1.Choose the whisk for the desirable effect. Whisk for milk frothing (1b). If you want your milk frothed. Whisk for heating the milk (1c). If
you want your milk heated.
2. Pour in a portion of milk (preferably 3.2% fat). The milk should cover the whisk (1b or 1c), and reach minimum level but not exceed the
maximum level mark (1d). Maximum level for milk heating is 300ml (2a) and for milk frothing is 130ml (2b).
NOTE: For best results use cold, fresh milk. Non-dairy milk doesn't froth as well as dairy milk. For best effect use "barista" type plant
based milk.
NOTE: Do not exceed the MAX line inside the jug.
3. Put the lid (1a) on the jug and place the jug on the power base (1h). Insert the power plug into an electrical outlet.
4. Press control button (1g) and choose desired program: cappuccino, latte, heating, cold.
- once - if you want to heat and froth your milk (with whisk 1b) to get the cappucino froth
- twice - if you want to heat and froth your milk (with whisk 1b) to get the latte froth
- three times - if you want only to heat your milk (with whisk 1c)
- four times - if you want your milk to keep cold and just froth it (with whisk 1b) for iced coffee or flavoured milk.
The light above the function will flash 2 seconds and milk frother will start working automatically.
5. The appliance will run until a high temperature of milk is reached. Once it's done it will stop automatically.
6. To turn off the appliance before the end of the cycle, press the control button once (1g) during work.
NOTE: DO NOT take off the jug from the power base (h) when it's operating.
NOTE: Milk heats to approximately 65°C. This temperature ensures the best flavor of the coffee.
CLEANING AND MAINTENANCE
1.Before washing the appliance, make sure it cooled down and is disconnected from the power socket.
2.Always remove the jug from the power base before cleaning.
3.Clean jug with a soft cloth and washing-up liquid.
4.The device should be washed after each use.
IMPORTANT: Do not submerge milk frother into water. The milk frother or any of its accessories are NOT dishwasher safe.
5.You can clean the frother by pouring water into it, adding a drip of dish soap and running for one cycle (this prevents the whisk from
blocking by milk sediments accumulating on the agitator shaft seal).
TECHNICAL DATA:
Power supply: 220-240V ~50/60Hz
Power: 500W
Capacity: frothed: 130ml / heated: 300ml
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
b. Whisk for milk frothing
d. Maximum filling level mark
f. Milk jug
h. Power base
4