Publicidad
Idiomas disponibles
Idiomas disponibles
-Solvent based lubricants used,
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(2) Main structure; (4) side bar (15)
Allen screw M8x25; (24) Self-tapping
screw 5x8; (37) Monitor; (68) Side bar
base cover (Left); (69) Side bar base
cover (Right); (40) Safety key; Allen
key 5mm; (124) Allen key 6mm; (99)
Bottle of lubricant.
Follow the instructions step by step to
assemble:
1 First of all take the right side bar
connect terminals Fig.1, then insert
the side bar into the bottom right-hand
support on the structure and use
screws (15) and (20).
2 Now take the left side bar (4) and
insert it into the bottom left-hand
support on the structure and use
screws (15) and (20) to secure it.
3 At least two people are needed for this
step. When fitting the side bars, one
person should hold the side bar while
Fig.B
the other one fits the screws (15). This
will prevent any possible accidents.
4 Position the lower left (68) and lower
right (69) covers with screw (22), then
position the left (6) and right (7)
metallized plate with screws (12) and
washers (30) (34) as shown in Fig.2.
FITTING THE MONITOR:
5 Connect the control cable terminal
Fig.3, coming out of the monitor, to the
control cable, sticking up from the right-
hand side bar , and insert screws (16),
making sure not to pinch the cables,
and screw in until hand tight.
Note:
Make sure that the cables do not
become caught up when the unit is
folded. Tighten the 4 screws (16) fully.
6 Position the left and right base covers
(78) and (79) in the direction of the
arrow facing the corresponding side bar,
as shown in Fig.4
FOLDING YOUR UNIT.-
This treadmill is equipped with a
folding
mechanism
purposes. To use it, stop the treadmill,
lower the elevation level to minimum,
unplug the mains cable and lift the unit
until you hear lever (55) click into
place, Fig.5. Store your unit in a dry
place,
preferably
changes in temperature.
UNFOLDING YOUR UNIT.-
If you wish to use the treadmill, do the
reverse procedure. Use your to press
lever (55) in the direction of the arrow
as shown in Fig.5 and slowly lower the
treadmill belt down to the floor.
17
for
storage
not
subject
to
Publicidad
