Publicidad
Idiomas disponibles
Idiomas disponibles
2610056649.qxp_GST18V-47 JSH180 6/19/20 9:42 AM Page 12
operation (Fig. 1).
To turn the tool "ON" slide the switch
button forward.
TO UNLOCK THE SWITCH, slide the
switch button backward.
Work Light
Your tool is equipped with work light for
better visibility during operation. When
the tool is turned on, the light turns on.
When the tool is turned off, the light
turns off.
Chip Blower
Your jig saw is equipped with an "always
on" blower to help keep the intended
cut line visible. . When the tool is turned
on, the blower is turned on. When the
tool is turned off, the blower is off.
Protection Against Deep
Discharging
The lithium ion battery is protected
against deep discharging by the
"Electronic Cell Protection (ECP)".
When the battery is empty, the tool is
switched off by means of a protective
circuit.
Temperature-dependent
Overload Protection
In normal conditions of use, the tool
cannot be overloaded. However, if the
power tool is overloaded or not kept
within
the
temperature range, the speed is
reduced or the power tool switches off.
If the tool speed is automatically
reduced in such situations, the tool will
run again at full speed once the
permitted battery temperature is
reached or the load is reduced. During
automatic shut-down, switch off the
power tool, allow the battery to cool
down, and then switch the power tool
back on (Fig. 1).
Brake
When the trigger is released it activates
the electrical brake to stop the blade
quickly. This feature is especially useful
when making repetitive cuts.
Operating Instructions
permitted
battery
Blade Orbit Selector Lever
Maximum cutting efficiency can be
obtained by adjusting the blade orbit
selector lever to suit the material being
cut.
The following chart will help you
determine which setting to use for your
application. This chart is intended as a
guideline only, and test cuts in scrap
material should be performed first to
determine the best setting.
Setting 0
Hard materials such as
metals or thin sheet metals.
This setting can be used
with knife blades, grit edge
blades, rasp work. and
down cutting blades.
Setting 1
Soft
cleaner cutting or delicate
scrolling work is performed.
Setting 2
Medium density materials
such as harder woods or
particle board.
Setting 3
Soft materials such as
wood, plastics, etc. and
when fast cutting is more
important than a clean cut.
Footplate Angle Adjustment
(Model JSH180 only)
The footplate may be tilted to allow
angle cuts up to 45° in either direction.
FOOTPLATE
FOOTPLATE
SCREW
-12-
materials
where
Fig. 6
BEVEL SCALE
Publicidad
