Bosch VCI Manual Del Usuario página 41

APPLICATION OF COUNCIL DIRECTIVE(S):
MANUFACTURER'S NAME/ADDRESS:
EUROPEAN REPRESENTATIVE'S
NAME/ADDRESS:
TRADE NAME:
PRODUCT UNDER TEST:
YEAR OF MANUFACTURE:
COUNTRY OF MANUFACTURE:
STANDARD(S) TO WHICH CONFORMITY IS DECLARED:
1. IEC 61010-1:2010
2. EN 61010-1:2001
3. EN 61326-1:2006
a. Class A for Radiated and Conducted Emissions
b. Immunity Test Requirements for industrial locations
c. ESD Performance Class B
4. ETSI EN 300 328 v1.7.1 (2007)
5. ETSI EN 301 489-3 v1.4.1 (2002)
I, the Manufacturer, hereby declare that the equipment as tested is representative within manufacturing tolerance to
units.
Manufacturer
Bosch Automotive Service Solutions Inc.
Location
655 Eisenhower Drive, Owatonna, MN 55060
Date
Name of Grantee: Wi2Wi, Inc.
FCC Identifier: U9R-W2CBW009DI
This device can be expected to comply with part 15 of the FCC Rules provided it is assembled in exact accordance with the
instructions provided with this kit. Operation is subject to the following conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.
DECLARATION OF CONFORMITY
EMC 89/336/EEC
R&TTE 1999/5/EC
Bosch Automotive Service Solutions Inc.
655 Eisenhower Drive
Owatonna, MN
55060
USA
Bosch Automotive Service Solutions GmbH
Porschestrasse 4,
63512 Hainburg,
Germany
VCI
VCI
2011
USA
Signature
Printed Name
Manohar Chinnadurai
Position
Engineering Manager
41