Herschel SUMMIT 2600 Instrucciones De Instalación Y Funcionamiento página 6

Mounting Hardware Includes:
•
4 x bracket pieces (fit together to form 2 brackets with central pivot)
•
4 x bolts with expansion plugs (for fitting brackets onto ceiling or wall)
•
2 x slider plates (fit into grooves on rear of heater)
•
4 x small bolts to fit brackets onto slider plates
•
4 x small bolts with nuts (to form the pivot on the brackets)
•
2 x screws (fit into slider plates to clamp the slider plate in position on the heater).
Diagram 3: Mounting options and minimum distances to objects.
CAUTION:
•
Ensure mains power is OFF before commencing installation.
•
The supplied mains cable must not contact the top surface of the heater during operation.
•
Heater must not be located immediately below a socket outlet. Electrical connections must be made
outside of the footprint of the unit to avoid heat build-up. If the heater is to be mounted on an incline
(e.g. sloping roof), ensure the electrical connection is located below the lowest end of the heater.
•
Joists, beams and rafters shall not be cut or notched to install the appliance.
•
This heater is not intended for ceiling-recessed installation.
•
The identification mark and model reference should be visible after installation.
•
The SUMMIT must not be attached facing or close to any combustible material (eg, wood or PVC
cladding, fascia or soffit) or other materials that could blow onto the heater.
•
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
must be protected, for example, by sleeving having an appropriate temperature rating.
OPERATION BY REMOTE CONTROLLER:
The Herschel SUMMIT 2600R is operated from the remote control supplied with the heater. The SUMMIT
2600 has no remote control.
Insert 2 x AAA Alkaline batteries into the remote control.
ENGLISH