Herschel SUMMIT 2600 Instrucciones De Instalación Y Funcionamiento página 7

Button Function (Heater On)
1 Turns heater on or off
2 Increase Heat Level or Timer
hours
3 Decrease Heat Level or Timer
Hours
4 Enable Timer adjustment
5 Enable Heat Level adjustment
•
If a heater with remote control is left switched on continuously for a week (168 hours), the heater
will automatically switch itself off and must be restarted.
•
Heaters with remote controllers are equipped with an overheat switch which will cut power to
the heater if it senses an overheat in the electronics. Please let the heater cool down for 15
minutes before attempting to restart.
INITIAL USE:
Before first use, ensure the emissive (front) surface is free of fingerprints and other contamination before
turning on heater for the first time. There may be an odour or vapour from the heater on initial use or if
heater has not been used for an extended period. This is normal.
USER MAINTENANCE:
Switch off the heater and allow it to cool completely. The SUMMIT may be wiped-down with a clean damp
cloth. Do not use abrasive detergents solvents or citrus-based cleaners to clean the unit. In marine or other
corrosive environments, the unit may be gently sprayed clean with clean water. After cleaning, it is advisable
to warm the heater for 10 – 20 minutes to dry the unit and prevent staining.
WARRANTY:
Register your product here:
https://www.herschel-infrared.com/customer-service/warranty-registration/
Remote Control Function
Function (Heater Off)
Turns heater on to Level 1
(minimum)
Turns heater on to Level 2
(Maximum)
1. POWER BUTTON: Turns heater on or off.
2. UP BUTTON: Increases the temperature and timer level.
3. DOWN BUTTON: Decreases temperature and timer level.
4. LEVEL BUTTON: Use to adjust heat levels (L1-L2). Press the
Level button then use the up and down buttons (2 and 3) to
increase or decrease the heating level.
5. TIMER BUTTON: Use to set the timer from 00 – 24 hours.
Adjust using buttons 2 & 3 to the number of hours you would
like to set.
All Herschel remote controls have the same frequency, so it is possible
to control several heaters with just one remote.
Safety & Energy-saving protection:
ENGLISH
LED Display on Heater
L1
L2
00 - 24
L [n]