Publicidad
Idiomas disponibles
Idiomas disponibles
IDENTIFICATION OF MANUFACTURER AND APPLIANCE
The nameplate shown here is fi tted directly to
the appliance. It contains references and all es-
sential information for operating safety.
Extra nameplate
A)
a
) Country of use
1
a
) Appliance category
2
a
) Type of gas
3
a
) Gas pressure
4
a
) Type of fume exhaust vent
5
Nameplate
B)
b
) Appliance model
1
b
) Type of customisation
2
b
) Manufacturer identifi cation
3
b
) Serial number
4
b
) Protection class
5
b
) EC conformity mark
6
b
) Reference standard
7
b
) EC certifi cate number
8
b
) Product family type
9
b
) Type of gas
10
For all requirements contact the agents or the
headquarters of Angelo Po which can be found
in the contacts section of the website http://
www.angelopo.com.
When requesting service, state the data provide
on the nameplate and provide a description of
the fault.
3320160_ut_GB_rev.1
PROCEDURE FOR REQUESTING SERVICE
b
) Rated power (kW)
11
b
) Gas consumption
12
b
) Testing gas indicator frame
13
b
) Voltage (V)
14
b
) Frequency (Hz)
15
b
) Electricity power consumption (W)
16
b
) Test voltage indicator
17
b
) Date of construction
18
Testing gas plate
C)
c
) Type of gas
1
c
) Gas pressure
2
The installer must select the plate (A) and apply
it alongside the nameplate relating to the coun-
try of use, and must mark the relative appliance
class (Type A = standard fume exhaust vent).
If the appliance is to be used with the same
type of gas as used by the manufacturer for test-
ing, the installer has to remove the plate (C) and
apply the indicator (b13) against the data of the
gas for use on the nameplate.
- 3 -
GB
ENGLISH
Publicidad
