Angelo Po 1N1PI1G Manual De Uso página 27

Lighting
Turn on the gas supply tap.
1)
Press and turn the knob (A) and turn it anti-
2)
clockwise (pos. 1), while keeping button (B)
pressed, to light the pilot light.
Keep the knob pressed for about 15 sec. to
prime the thermocouple.
Turn the knob (A) anti-clockwise (pos. 2) to
3)
light the burner.
Turn the knob (A) gradually anti-clockwise
4)
to adjust the power of the fl ame down to the
minimum setting (pos. 3).
Turning off
Turn the knob (A) clockwise (pos. 1) to turn
1)
the burner off . The pilot light will remain on to
allow the burner to be re-lit.
Turn the knob (A) clockwise (pos. 4) to turn
2)
off the pilot light.
Turn off the knob to ensure safety.
3)
To carry out this operation, proceed as follows.
Raise the lid (A).
1)
Turn the water spout (B) towards the pan.
2)
Turn on the water taps (C) to fi ll the pan to a
3)
level between the two marks (D).
For faster boiling times, use hot water
only; use cold water only when specifi cally
required.
Turn the water spout outward and then close
4)
the lid (A) and tighten the clamps (E).
Caution - Warning
Never use the appliance with no water in the
well, as this may damage its structure.
To drain the pan turn on the tap (F).
5)
Caution - Warning
Before draining the pan or opening the lid
(A), press the button (G) to discharge the
remaining steam (for version 1N1PI1GA-
1N1PI2GA only).
3320160_ut_GB_rev.1
SWITCHING THE BURNER ON AND OFF
FILLING THE PAN
A
4
B
D
A
C
F
- 9 -
A
B
1
2
3
G
E
ENGLISH
GB