Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Power On/Off
Power On
The siren is powered off in default setting. Plug the siren into AC
power socket, and then press the power switch button. The siren is
powered on after a long beep.
Power Off
Press connect button once under working status. Then press the
connect button for 6 seconds until a long beep is heard. The siren is
powered off.
Strobe Light Indication
When armed, the strobe light will be on after one flash.
When disarmed, the strobe light goes out after two flashes.
Work as Wireless Siren
When it works as a wireless siren, the siren should be connected
with wireless control panel in advance. When the control panel is
alarming, the siren hoots and the strobe light flashes to deter illegal
intruders.
Connect to Control Panel
Firstly, press the connect button (0.5 seconds), the wireless siren
beeps once. 3 seconds later, it gives out another beep and the
strobe light flashes, then the siren goes into connecting status.
Secondly, press
[SOS]
or
[Arm]
button on the panel, the wireless
siren and control panel are connected successfully after one beep.
Press connect button again to exit connecting status after one beep.
Notes:
Please don't trigger any accessory when connecting with the control
panel.
Testing:
Press the
[Arm]
button on the remote control, if the built-in siren
of control panel and wireless siren beep once, the connection is
successful. If not, the connection fails, please reconnect them.
Work as Standalone Alarm
The siren can build up a standalone alarm system by adding
wireless accessories.
When the siren is armed, if any sensor is triggered, the siren will
hoot and strobe light will flash to deter illegal intruders.
EN
Publicidad
