Publicidad
Idiomas disponibles
Idiomas disponibles
Over 15mm (5/8")
Over 420mm (16-1/2")
1
85mm
70mm
(3-3/8")
(2-3/4")
1. Holes
002206
CAUTION:
Use the straight wood of even thickness as the
•
wood facing.
WARNING:
Use screws to attach the wood facing to the
•
guide fence. The screws should be installed
so that the screw heads are below the surface
of the wood facing so that they will not
interfere with the positioning of the material
being cut. Misalignment of the material being cut
can case unexpected movement during the cutting
operation which may result in a loss of control and
serious personal injury.
NOTICE:
When the wood facing is attached, do not turn the
•
turn base with the handle lowered. The blade
and/or the wood facing will be damaged.
8.
Cutting repetitive lengths
3
001846
When cutting several pieces of stock to the same
length, ranging from 220 mm (8-5/8") to 385 mm
(15-1/8"), use of the set plate (optional accessory)
will facilitate more efficient operation. Install the set
plate on the holder (optional accessory) as shown
in the figure.
Align the cutting line on your workpiece with either
the left or right side of the groove in the kerf board,
and while holding the workpiece from moving,
move the set plate flush against the end of the
workpiece. Then secure the set plate with the
screw. When the set plate is not used, loosen the
screw and turn the set plate out of the way.
50mm-60mm
(2"-2-3/8")
27mm (1-1/16")
1
70mm
85mm
(2-3/4")
(3-3/8")
1. Set plate
2. Holder
1
3. Screw
2
NOTE:
Use
of
the
•
accessory) allows cutting repetitive lengths up to
2,200 mm (7.2ft) approximately.
9.
Groove cutting
1
001563
A dado type cut can be made by proceeding as
follows:
Adjust the lower limit position of the blade using
the adjusting screw and the stopper arm to limit the
cutting depth of the blade. Refer to "Stopper arm"
section described on previously.
After adjusting the lower limit position of the blade,
cut parallel grooves across the width of the
workpiece using a slide (push) cut as shown in the
figure. Then remove the workpiece material
between the grooves with a chisel.
WARNING:
Do not attempt to perform this type of cut by
•
using a wider type blade or dado blade.
Attempting to make a groove cut with a wider blade
or dado blade could lead to unexpected cutting
results and kickback which may result in serious
personal injury.
Be sure to return the stopper arm to the
•
original position when performing other than
groove cutting. Attempting to make cuts with the
stopper arm in the incorrect position could lead to
unexpected cutting results and kickback which
may result in serious personal injury.
Carrying tool
1
011300
18
holder-rod
assembly
1. Cut grooves with
blade
1. Stopper pin
(optional
Publicidad
