Siemens milltronics MSI Guia De Inicio Rapido página 7

Installation Procedure
1. Remove the conveyor idler (s) and the idler foot plate(s) from the desired installation
point and modify the idler frame at both ends of the idler as shown below.
customer's idler
before
2. Insert the MSI(s) in the place of the removed idler(s). Install the mounting bolts and
nuts but do not tighten. Remove the idler clips from the scale (see diagram below).
belt travel
MSI belt scale
Be sure there is sufficient clearance between the return belt, MSI(s), and its
Note:
test weight(s) (when calibrating).
3. Position the individual MSI(s) so they are centered and square to the stringer. Center
the modified idler on the scale using the idler clips. Tighten all mounting hardware.
The large arrow on the scale mounting brackets should point in the direction of belt
travel.
conveyor stringer
(typical)
7ML19985XK81
after
idler clips
Milltronics MSI/MMI – QUICK START MANUAL
12.7 mm
(0.5")
100 mm
(4")
location of
removed idler
test weight(s)
Page EN-5