Siemens milltronics MSI Guia De Inicio Rapido página 8

4. Release the shipping stops on each MSI to free the weighing mechanism. Loosen ' A '
screws and rotate both shipping stops inward until the underside slots slide around
the shoulder 'B' screws. Tighten ' A ' screws.
5. Properly align and level idlers in the weighing area by shimming the scale idler, the
two approach idlers (A1, A2), and the two retreat idlers(R1, R2), until they are within
± 0.8 mm (1/32") of each other. Idlers must be centered and squared to the conveyor
during the shimming process.
alignment of
idlers A2 to R2 to
be within
A 2
± 0.8 mm (1/32")
Page EN-6 Milltronics MSI/MMI – QUICK START MANUAL
' A ' screws
'B' screws
shipping stop
belt travel
belt travel
A 1
shipping stop
90°
idlers must be square to stringers
R 2
R 1
center of
idlers to be
in line
7ML19985XK81