After Use - Makita M2300 Manual De Instrucciones

Sierra de inglete mixta
Ocultar thumbs Ver también para M2300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
Fig.40
► 1. Triangular rule 2. Saw blade 3. Top surface of
turn base
Fig.41
► 1. Pointer
45° bevel angle
Fig.42
► 1. 45° bevel angle adjusting bolt 2. Pointer
Adjust the 45° bevel angle only after performing 0°
bevel angle adjustment.
To adjust left 45° bevel angle, loosen the knob and tilt
the blade to the left fully.
Make sure that the pointer on the arm points to 45° on
the bevel scale on the arm.
If the pointer does not point to 45°, turn the 45° bevel
angle adjusting bolt on the left side of the arm until the
pointer points to 45°.
Replacing carbon brushes
2
3
Fig.43
Remove and check the carbon brushes regularly.
Replace when they wear down to 3 mm (1/8") in length.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
Fig.44
1
► 1. Brush holder cap 2. Screwdriver

After use

After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
2
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
14 ENGLISH
1
2

Publicidad

Tabla de contenido
loading

Tabla de contenido