Publicidad
Outlet #1
Hot Water Inlet
Pipe Connections to the Valve
Connect the piping to the valve as shown above.
If soldering copper to copper, be sure to remove the
cartridges prior to soldering (see Cartridge removal
step).
NOTE: Do not use outlet port on Moentrol Valve.
Unplugging and use of this port will cause improper
functioning of the valve.
MOEN LIFETIME LIMITED WARRANTY
Moen products have been manufactured under the highest standards of quality and work-
manship. Moen warrants to the original consumer purchaser for as long as the original con-
sumer purchaser owns their home (the "Warranty Period" for homeowners), that this faucet will
be leak and drip-free during normal use and all parts and finishes of this faucet will be free
from defects in material and manufacturing workmanship. All other purchasers (including pur-
chasers for industrial, commercial and business use) are warranted for a period of 5 years from
the original date of purchase (the "Warranty Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE
OF CHARGE provide the parts necessary to put the faucet back in good working condition and
will replace FREE OF CHARGE, any part or finish that proves defective in material and manufac-
turing workmanship, under normal installation, use and service. Replacement parts may be
obtained by calling 1-800-289-6636 (Canada 1-800-465-6130), or by writing to the address
shown. Proof of purchase (original sales receipt) from the original consumer purchaser must
accompany all warranty claims. Defects or damage caused by the use of other than genuine
Moen parts are not covered by this warranty. This warranty is applicable only to faucets pur-
chased after December 1995 and shall be effective from the date of purchase as shown on pur-
chaser's receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes.
However, damage due to installation error, product abuse, product misuse, or use of cleaners
containing abrasives, alcohol or other organic solvents, whether performed by a contractor,
service company, or yourself, are excluded from this warranty. Moen will not be responsible for
labor charges and/or damage incurred in installation, repair or replacement, nor for any indi-
rect, incidental or consequential damages, losses, injury or costs of any nature relating to this
faucet. Except as provided by law, this warranty is in lieu of and excludes all other warranties,
conditions and guarantees, whether expressed or implied, statutory or otherwise, including
without restriction those of merchantability or of fitness for use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to you. This war-
ranty gives you specific legal rights and you may also have other rights which vary from state
to state, province to province, nation to nation. Moen will advise you of the procedure to fol-
low in making warranty claims. Simply write to Moen Incorporated using the address below.
Explain the defect and include proof of purchase and your name, address, area code and tele-
phone number.
3
Outlet #2
Cold Water Inlet
Before installing the IPS version of the valve, CC to
IPS adapters need to be soldered into the outlet
ports of the transfer valve as shown. Remove the
transfer valve cartridge before soldering the
adapters.
Cartridge Removal (for soldering only)
The cartridges will need to be removed prior to
soldering the copper piping to the valve.
1. Remove the cartridge retainer clips using a
pic or similar tool by pulling the clips up and
out through the top slot.
2. Once the retainer clips are removed, use a
pair of pliers to pull the cartridges out of the
valve body.
3. Re-install the cartridges to their correct
locations after the valve body has
returned to room temperature.
4. Re-install cartridge retainer clips.
CONSUMER INFORMATION
Faucets made of leaded brass alloys may contribute small amounts of lead to water
that is allowed to stand in contact with the brass. The amount of lead contributed by
any faucet is highest when the faucet is new. The following steps may reduce poten-
tial exposure to lead from faucets and other parts of the plumbing system:
• Always run the water for a few seconds prior to use for drinking or cooking
• Use only cold water for drinking or cooking
• If you wish to flush the entire plumbing system of water that has been stand-
ing in the pipes or other fittings, run the cold water until the temperature of
the water drops, indicating water coming from the outside main
• If you are concerned about lead in your water, have your water tested by a cer-
tified laboratory in your area
1 (800) BUY-MOEN
In the U.S. call our toll free Helpline number, for answers to any
product installation, or warranty questions.
Rest of Canada: 1-800-465-6130
Moen Incorporated • 25300 Al Moen Drive • North Olmsted, OH 44070-8022 U.S.A.
In Canada Moen Inc. • 2816 Bristol Circle • Oakville, Ontario L6H5S7
HELPLINE:
[289-6636]
In Canada:
Toronto: 905-829-3400;
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84-345
INS1545
Publicidad
