Publicidad
Idiomas disponibles
Idiomas disponibles
Fuse specification
AMG Heavy Duty 300Ah
WARNING! KEEP AWAY FROM SPARKS
AND FLAMES – BATTERY COULD EMIT
EXPLOSIVE GASES.
1. Allow the fuse to cool down
completely (approximately 5 minutes).
2. Make sure the unit is unplugged from
the external charger.
3. Remove the positive (RED) clamp
from the storage compartment on the
side of the unit and locate the fuse
holder.
4. Open the fuse holder by removing its
cover.
5. Using a wrench, remove the first nut
and bolt securing the fuse on the
positive cable. Repeat the same steps
for the second nut and bolt. Remove
the open fuse and replace it with a
new one of the same type and rating.
6. Tighten the nuts and bolts to secure
the fuse, and then replace the cover of
the fuse holder.
7. The unit is now ready to use.
9. MAINTENANCE INSTRUCTIONS
9.1 After use and before performing
maintenance, unplug and disconnect the
booster.
9.2 Use a dry cloth to wipe all battery corrosion
and other dirt or oil from the battery
clamps, cords, and the booster's case.
10. MOVING AND STORAGE INSTRUCTIONS
10.1 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
The internal battery will gradually
self-discharge (lose power) over time,
especially in warm environments. Leaving
the battery in a discharged state may
result in permanent battery damage.
10.2 Store inside, in a cool, dry place.
The ideal storage temperature is between
50°-77°F (0°-25°C).
8.3 Powering a 12V DC Device:
The booster is a power source for all 12V
DC accessories that are equipped with
a 12V accessory plug. Use it for power
outages and fishing or camping trips.
Make sure the device to be powered
is OFF before inserting the 12V DC
accessory plug into the 12V DC
accessory outlet.
1. Open the protective cover of the DC
power outlet on the front of the booster.
2. Plug the device into the outlet and turn
the device on (if required).
3. If the device draws more than 15A or
has a short circuit, the internal circuit
breaker of the booster will trip and
disconnect the power to the device.
Disconnect the device and the breaker
will automatically reset.
IMPORTANT: The DC power outlet is
wired directly to the internal battery.
Extended operation of a 12V device may
result in excessive battery drain. Recharge
immediately after unplugging the device.
9.3 Ensure that all of the booster's
components are in place and in good
working condition, including the plastic
boots on the battery clamps.
9.4 All servicing should be performed by
qualified service personnel.
10.3 Clamps must be stored on their support
posts, to make sure they do not come to
contact with any metallic surface.
10.4 If the booster is moved around the shop
or transported to another location, take
care to avoid/prevent damage to the
cords, clamps and the unit. Failure to
do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store
the booster in or on any area or surface
where damage could occur if the internal
battery should unexpectedly leak acid.
• 9 •
Publicidad
