Publicidad
3 POINT LIFT MODEL ASSEMBLY
2208 Lift Model with Twin
Beam Tailwheel selection
1. Install (2) bushings between the LH and RH Struts using 3/4" x 2-1/2" capscrews and 3/4" lock-
nuts at each location.
2. Place the LH and RH Flex Yokes together and align the slotted holes. Place a Bushing into
the slotted holes.
3. Install the Flex Yokes with Bushing between the Struts so the slanted end is toward the ground
and rest atop the bushing previously installed. Align the holes of the struts and the bushing in
the yokes.
4. Insert a 3/4" x 2-1/2" Capscrew and fasten with a 3/4" Locknut.
5. Tighten all fasteners.
RH Flex Yoke
LH Flex Yoke
Bushing into slotted hole
2208 SERIES 05/21
© 2021 Alamo Group Inc.
ASSEMBLY
FLEX LINK ASSEMBLY
Bushings
Between Struts
Capscrews 3/4" x 2-1/2"
and Locknuts 3/4"
Assembly Section 3-4
RH Strut
LH Strut
Publicidad
