Descargar Imprimir esta página

Bush Hog 2208 Serie Manual Del Operador página 103

Publicidad

1. Remove Tongue assembly from shipping position and assemble to lower front holes of the hitch plates
(NOTE: be sure the pivot bushings remain inside the pivot tubes of the tongue.) Install the 1" x 8" cap-
screws through the tongue pivot tubes and secure with 1" locknuts.
2. Install the Leveling Rod to the tongue with the clevis that has the slotted holes. Place a 1" flatwasher to
each side against the slotted hole and insert the clevis pin. Secure with the 3/16" x 1-1/2" Cotter Pins.
3. Attach the Leveling Rod to the Axle Lugs with the Clevis Pin and two 3/16" x 1-1/2" Cotter Pins.
4. Hose Holder is placed atop the hole in the plate between the Hitch Plates. Place a 1/2" Flatwasher on
top of the mounting loop of the Hose Holder and insert a 1/2' x1-1/2" Capscrew through the assembly
securing with a 1/2" Locknut to the underside of the plate.
2208 SERIES 05/21
© 2021 Alamo Group Inc.
ASSEMBLY
PULL MODEL ASSEMBLY
PULL MODEL ASSEMBLY
(Refer to Illustration on next page)
Assembly Section 3-7

Publicidad

loading

Este manual también es adecuado para:

2208r