Publicidad
CV DRIVELINE SAFETY SHIELD
To remove the outer CV cone, remove the locking screws from shield cone. Remove cone over yoke. Figure
Mnt-R-0038 Remove bearing ring and remove the locking screws from inner shield cone. Figure Mnt-R-0038.
Turn inner cone to assembly position and remove half shield. Remove bearing ring. FIGURE MNT-R-0038.
To assemble outer CV driveline, grease yoke groove and inner profile tube. Attach bearing ring on groove with
recesses facing profile tube. FIGURE MNT-R-0039. Slide on half shield with cone. Turn cone until it engages
correctly. FIGURE MNT-R-0039. Tighten locking screws. Grease bearing groove in double yoke. FIGURE
MNT-R-0039. Insert bearing ring. Slide guard cone for double yoke over cam from the connecting end. Make
sure holes for screws are visible. FIGURE MNT-R-0039. Tighten locking screws. FIGURE MNT-R-0039.
IMPORTANT: Scan this QR Code with your smart phone to link to the ADMA
Driveline Safety Manual for more information on the safe use of a driveline during
normal operation and maintenance. Or type in your internet browser the following
web address: www.algqr.com/dme
2208 SERIES 05/21
© 2021 Alamo Group Inc.
MAINTENANCE
Ops-0009-MISC
Maintenance Section 5-9
Publicidad
