Publicidad
219W, 220W, 227W, & 228W 2-Door Kits
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Head Screwdriver, Scissors or Knife.
N
— Glass Retainer
FIG. 1A
FOR 219W & 228W ONLY:
1. The Glass Door Frames (A) come with the Glass (M) in place for security during shipping. It
is held in place by small pieces of retainer which should be removed with the glass prior to
finishing the doors.
Place the Glass Door Frames (A) on a clean protected surface and insert the Door Glass (M)
in the notch. Cut the Glass Retainer (N) into eight pieces equal to the length and width of the
glass for both doors. Lay glass retainer pieces flat on the glass and press notched edge into
the door frame along the glass. NOTE: Cutting the Retainer at a 45-degree angle will give
a more finished look.
CAUTION: DO NOT LEAN ON THE GLASS WHEN WORKING ON THE DOOR.
2. Use the compatibility chart below to determine location of the doors you wish to hang on
either your base or hutch.
Door Kit
219W, 220W,
227W
or 228W
o
225W Standard
2-Shelf Hutch
226W Standard
3-Shelf Hutch
USE WITH
223W Standard
Bookcase Base
or
224W Standard
Console Base
M
Hutch or Base
Scissors or Knife
FIG. 1B
Hinge Plate Location
Use predrilled holes in top
and middle locations.
Cannot be used
together.
Use predrilled holes
in top and bottom
locations.
219W, 220W, 227W, 228W — Page 3
Publicidad
