Publicidad
C
x 8
Hinge
F
x 8
Arm
C
C
3. Lay the Door (A) face down on a clean protected surface. Place one Hinge (B) into each of the
holes in the back of the door. Line up the screw holes in the hinge with the predrilled holes in
the door and insert Screw (C). See FIGURE 3A.
The side Panels of the base and hutch units are predrilled for the hinge location (see
compatibility chart in step 2 for proper location). Attach two Hinge Plates (D) with Hinge
Spacers (E), with the longer arm facing out (arrow on the plate points out), using Screw (F) in
the holes. See FIGURE 3B. Repeat for the other side.
H
x 2
G
x 2
FIG. 4
4. Attach the Tuscan Bronze Knobs (G) to the Doors (A) with Screws (H). See FIGURE 4.
Page 4 — 219W, 220W, 227W, 228W
DOOR (A)
B
FIG. 3A
F
F
H
SIDE PANEL
E
D
FIG. 3B
G
Publicidad
