Omron HBP-1120 Manual De Instrucciones página 27

Troubleshooting
In case of any of the below problems occur during use, first check that
no other electrical device is within 30 cm. If the problem persists, please
refer to the table below.
The power does not turn on
Cause
If the unit is being powered by the
batteries, the batteries are not
installed or depleted.
The AC adapter is disconnected.
If the power does not turn on and the above is not the cause, turn off
the unit power, disconnect the AC adapter, remove the batteries, and
contact your OMRON retail dealer or distributor.
The unit display does not operate
Cause / solution
Stop using the unit and contact your OMRON retail dealer or distributor.
The unit becomes hot
Cause
An object is on top of the unit or
right next to the unit.
If the unit becomes too hot to be touched, there may be a problem in
the unit. Turn off the unit power, disconnect the AC adapter, remove the
batteries, and contact your OMRON retail dealer or distributor.
The cuff does not inflate when the [START/STOP] button is pressed
Cause
Loose cuff tube connection.
There is an air leak in the cuff.
If pressure is displayed, the cuff
tube is bent.
Solution
Insert batteries or replace with new
batteries (page 13).
Connect the AC adapter (page 13).
Solution
Keep the area around the unit free
of objects.
Solution
Check the connection.
Replace the cuff.
Make sure no part of the cuff tube
is bent.
EN
25