Fanimation LP8377LBL Manual De Instrucciones página 10

NOTE: If fan or supply wires are different colors than
indicated, have this unit installed by a qualified electrician.
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote control. (Figure 1)
NOTE: The remote unit has 32 different code
other remote units, simply change the combination code
NOTE: Factory setting is all up. Do not use this position.
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
2. Slide the receiver into the hanger bracket before wiring
as shown in figure 3.
How to Wire Your Ceiling Fan
WARNING
Dip Switch
ON
1 2 3
Remote Control
Dip Switch
Receiver
NOTE: Supply wires
omitted for clarity
10
Receiver
4 5
Figure 1
MAIN FUSE BOX
Figure 2
Hanger Bracket
Dip Switch
Figure 3