Fanimation LP8377LBL Manual De Instrucciones página 17

For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
Trouble
1. FAN WILL NOT
START
2. FAN SOUNDS NOISY
3. FAN WOBBLES
EXCESSIVELY
4. REMOTE CONTROL
DOES NOT WORK.
THE CONTROL
INDICATOR LED IS
CONSTANTLY
FLASHING.
5. NOT ENOUGH AIR
MOVEMENT
Troubleshooting
Probable Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan,
or loose switch wire connections in the
switch housing.
3. Dead battery in remote control.
4. Reverse switch in neutral position.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Wire connectors inside housing rattling.
4. Motor noise caused by solid state variable
speed control.
1. Setscrew and nut in downrod support is
loose.
2. Setscrew in downrod/hanger ball assembly
is loose.
3. Screws securing fan blade to motor hub
are loose.
4. Hanger bracket and/or ceiling outlet box is
not securely fastened.
1. The battery/batteries are going to
run out.
WARNING
1. Check main and branch circuit fuses or
2. Check line wire connections to fan and
CAUTION: Make sure main power is
3. Replace with new battery.
4. Make sure reverse switch position is all the
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor
3. Check to make sure wire connectors in
CAUTION: Make sure main power is
4. Some fan motors are sensitive to signals
1. Tighten both setscrews and nuts securely in
2. Tighten the setscrew in the downrod/hanger
3. Check to be sure screws which attach the
4. Tighten the hanger bracket screws to the
1. Please replace the battery/batteries.
1. If possible, consider using a longer downrod
(notincluded, you can buy the longer downrod
fromfanimation.com).
17
Suggested Remedy
circuit breakers.
switch wire connections in the switch
housings.
turned off !
way to one side.
housing are snug (not over-tight).
switch housing are not rattling against each
other or against the interior wall of the switch
housing.
turned off !
from solid-state variable speed controls.
Solid-state controls are not recommended,
choose an alternative control method.
downrod support.
ball assembly.
fan blade to the flywheel are tight.
outlet box and secure outlet box.