Descargar Imprimir esta página

sunjoe SPX205E-XT Manual Del Operador página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the adjustable spray wand
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
1. The washer is equipped with an adjustable nozzle.
2. The water pressure can be adjusted from low pressure (–)
to high pressure (+) by turning the pressure adjustment
knob. The nozzle tip can be adjusted from pencil spray
(wide open tip) to fan spray (narrow tip) by turning the
nozzle tip adjustment knob (Fig. 13).
Pressure
adjustment knob
Pencil spray
Nozzle tip
Nozzle tip
adjustment knob
Fig. 13
m
WARNING!
Do not adjust the nozzle while the trigger
is squeezed. Failure to do so could result in damage.
Recommended cleaning procedure
1. For additional cleaning power, a detergent spray
bottle attachment (Model SPX1DT) is available as an
add-on accessory for the SPX205E-XT. Visit sunjoe.com
to purchase.
m
CAUTION!
Only use detergents specifically
recommended for use with pressure washers.
2. Load the bottle with a suitable, non-corrosive detergent
and attach it the spray gun (Fig. 14).
Fig. 14
Detergent spray bottle
(Model SPX1DT)
3. With the nozzle tip adjusted to a low-pressure fan spray,
apply detergent from the bottom to the top of the dry
surface to be cleaned. Applying detergent in this manner
will dissolve dirt most effectively.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
4. Allow the detergent to remain on the surface for a short
time before rinsing with the pressure washer. Do not allow
the detergent to dry on the surface.
Shutting down
1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Fan spray
Taking a break
If you are taking a break of five minutes or more between
cleaning tasks:
1. Engage the gun safety lock (Fig. 12).
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Storage
m
CAUTION!
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from all hoses, the pump, and the
detergent bottle (if using) before storing.
m
CAUTION!
recommended to prevent cold weather damage during storage
over the winter months.
10
Turn off the water supply and squeeze the
Always store your pressure washer in a
The use of a pump protector is

Publicidad

loading