Publicidad
Idiomas disponibles
Idiomas disponibles
USING Bluetooth
1. Turn the speaker on.
2. The speaker should already be in Bluetooth mode. If not, press the Bluetooth button (3).
3. Find "P3BTS" under devices on your Bluetooth enabled device and select to pair. The
blue light will flash while the pairing takes place. Once the pairing is successful the blue light
will remain steady.
4. Begin playing music on your device.
NOTE: The speaker does not have to be in the Bluetooth mode when pairing, only when listening.
®
*The Bluetooth
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
and any use of such marks by BLACK+DECKER is under license. Other trademarks and trade
names are those of their respective owners.
LISTENING IN AUXILIARY MODE
To listen to a device in auxiliary mode, press and hold the Bluetooth button (3) until the blue
light turns green. Plug the auxiliary jack (5) into the auxiliary port of your device. When
finished, unplug the jack and store it in the auxiliary jack holder (6).
INCOMING CALL
If your phone receives a call while it is connected to the speaker it will ring through the speaker.
Samsung**
To transfer the call to your phone, deselect the headset option on your phone. The
speaker will remain mute until the call is over.
End the call normally with your cell phone. The speaker will resume previous function.
®
**Samsung
is a registered trademark of Samsung Group.
®
iPhone
***
To transfer the call to your phone, select "audio source" on your phone, then select
"iPhone." The speaker will remain mute until the call is over.
End the call normally with your cell phone. The speaker will resume previous function.
®
***iPhone
is a registered trademark of Apple Inc.
PROBLEM
• Unit will not
power on
®
WIRELESS TECHNOLOGY *
TROUBLESHOOTING
POSSIBLE CAUSE
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
• Battery not charged.
• Battery is not fully connected. • Push battery fully into battery port
• Battery does not have
enough power.
• Battery has been removed.
• Adapter unplugged without
battery in place.
POSSIBLE SOLUTION
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a BLACK+DECKER
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a
BLACK+DECKER service center
or authorized servicer.)
• Have cord or switch replaced
at a BLACK+DECKER Service
Center or Authorized Servicer
• Charge battery.
and ensure it is properly connected.
• Charge battery.
• Replace battery.
• Plug adapter into outlet or
properly insert battery.
5
Publicidad
