Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
If ignition does NOT occur within 5 seconds, turn
the control knob off ( O ) and wait 5 minutes. Repeat
lighting procedures. If burner does NOT ignite with
the cylinder valve open, gas will continue to flow of
the burner and could accidently ignite and result in
serious personal injury.
IGNITING THE MAIN BURNER
See Figures 27 - 28.
NOTE: Never lean over the grill while lighting burners.
The first time you use your newly purchased grill, it is
recommended the grill run on the highest setting for
15 - 20 minutes.
To ignite burners using the electric ignitor:
Open the hood.
Turn all control knobs on the control panel off ( O ).
Make sure the regulator is tightly connected to the LP
gas cylinder and a leak test has been performed.
Open the cylinder valve completely.
Push in the far left control knob and turn to ON
Press and hold the electric ignitor until the burner lights.
When burner is lit, turn the control knob to the desired
setting.
If burner fails to light within five (5) seconds, release the
electric ignitor. Turn the control knob off and wait five (5)
minutes then repeat the step.
NOTE: Place burner on high and observe flame height
which should be approximately 1 inch. If the flame is
too high or too low, burner adjustment is required. See
Adjustment section later in this manual.
To light adjacent burners: push in and turn on the control
knob next to the lit burner to light; or, repeat the lighting
procedures for non-adjacent burners.
OPERATION
ELECTRIC
IGNITOR
CONTROL
KNOB
.
Fig. 27
20
Publicidad
