Descargar Imprimir esta página

Front Runner KRTP011T Instrucciones De Montaje página 5

Publicidad

FIT THE RACK
3
Note: If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal
Assembly Instruction (Document RRSTUNI). Read Step 3A before fitting the Wind Deflector
A
(
)
Before fitting the Wind Deflector, and with
the Rack in the upside down position,
(Check with product sticker. It should be
upside down), slide a M8 x 20 Hex Bolt (Item
5) into each end of the First Slat using the
machined slot as shown.
B
(
)
With your rack still upside down from Step 3A, slide a M8 x 20 Hex Bolt (Item 5) into the end of Slats 4, 5,
9, 10.
Grab your Friend and with one of you on each side of the Rack, flip the Rack end over end (This prevents
the Hex Bolts from falling out of the machines slots) so that the M8 x 20 Hex Bolts are facing down.
Approach the vehicle from the rear, with the Wind Deflector facing forward. Lift the Rack up and over the
Roof positioning it above the Foot Rail. Bring the Rack down slowly, lining up the Bolts in the Rack with
the holes in the top of the Foot Rail. Hand tighten the Rack to the Foot Rail using the M8 Washers and M8
Nyloc Nuts (items 6 & 7) supplied.
Center the rack - left to right (check using a tape measure). Fasten all the Nuts securing the Rack to the
Foot Rail. Cover the M8 Nyloc Nuts with the M8 Nut Caps (item 1) supplied.
Congratulations, you have completed your instillation. Take a step back and admire your work. Good Job!
REV_A02
5

Publicidad

loading

Este manual también es adecuado para:

Fatp001Krle007t