Publicidad
fouling the filters installed in the appliance to protect the water intake
valves.
The new intake hose supplied with the appliance must be used, and the old
water supply hose must not be used.
Supplementary note regarding the water connection for the German mar-
ket.
Before connecting the product to the water supply, make sure that the water
system has been fitted with a safety device to protect drinking water against
contamination due to backflow (according to DIN EN 1717). The water valves
and/or taps are fitted with these safety devices if the water system of the house
has been properly implemented.
2.4 CONNECTING TO THE DRAIN
1.
Insert the end of the drain hose into a drain pipe having inside diameter of
at least 4 cm, at least 50 to 90 cm above floor level, or connect it securely
(using the plastic fitting on the elbow in the hose) to a sink or bathtub.
2.
In all cases, check that the end of the drain hose is securely fixed to pre-
vent the repulsive force of the water from pushing it out of place.
WARNING!
Avoid kinks or restrictions to ensure effective drainage.
Any drain hose extensions must be no more than 1 metre long, must be of
the same diameter and must be free from restrictions of all kinds.
The end of the drain hose must never be submerged in water.
EN
10
Publicidad
